Secondary Shutter Valve (SSV) Solenoid Valve Inspection: Notes

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the SSV solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
Inspect for airflow using the steps in the table below.

Fig 1: Continuity Airflow Chart
Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying SSV Solenoid Valve Connector Terminal
Courtesy of MAZDA MOTORS CORP.
- If it is normal, inspect related wiring harnesses.
- If there is any malfunction, replace the SSV solenoid valve.