LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 433 (Engine Mechanical (Service Information)) >> Rear Oil Seal Replacement >> Rear Oil Seal Installation Note

Rear Oil Seal Installation Note

WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply engine oil to the lip of a new rear oil seal.
  2. Tap the rear oil seal evenly in the stationary gear using the SST. 
    CAUTION:
    • Insert until it is attached to the seating face.
    • Do not damage the oil seal lip by catching it on the eccentric shaft and the key.
    Fig 1: Installing Rear Oil Seal
    G03701802Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals