LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 419 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures (Standard Deployment Control System) >> Deployment Procedure for Outside of Vehicle >> Passenger-side air bag module

Passenger-side air bag module

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the passenger-side air bag module. (See PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION (STANDARD DEPLOYMENT CONTROL SYSTEM) .)
  2. Install the bolts to the passenger-side air bag module.
    WARNING:
    • If the air bag module is not properly installed to the tire, serious injury may occur when the module is deployed. When installing the air bag module to the tire, make sure the module is facing the center of the tire.
    Fig 1: Installing Bolts To Passenger-Side Air Bag Module
    G03700894Courtesy of MAZDA MOTORS CORP.
  3. Tie the passenger-side air bag module to a tire with the module facing the center of the tire. Wrap the wire harness through the tire and around the bolts at least four times. 
    Fig 2: Tying Passenger-Side Air Bag Module To Tire
    G03700895Courtesy of MAZDA MOTORS CORP.
  4. Connect the SST  (Adapter harness) to the passenger-side air bag module as shown in Fig 3.
    Fig 3: Connecting SST (Adapter Harness) To Passenger-Side Air Bag Module
    G03700896Courtesy of MAZDA MOTORS CORP.
  5. Stack the tire with the passenger-side air bag module on top of two tires. Stack a tire on top of the three tires. Stack another tire that has a wheel on top of the four tires.
    Fig 4: Stacking Tires (For Passenger-Side Air Bag Module Deployment)
    G03700897Courtesy of MAZDA MOTORS CORP.
  6. Tie all tires together with wire.
    Fig 5: Tying All Tires Together With Wire
    G03700898Courtesy of MAZDA MOTORS CORP.
  7. Connect the SST  (Deployment tool) to the SST  (Adapter harness).
    Fig 6: Connecting SST (Deployment Tool) To SST (Adapter Harness)
    G03700899Courtesy of MAZDA MOTORS CORP.
  8. Connect the red clip of the SST  (Deployment tool) to the positive battery terminal and the black clip to the negative battery terminal.
  9. Verify that the red light on the SST  (Deployment tool) is illuminated.
  10. Make sure all persons are standing at least 6 m {20 ft}  away from the tires.
  11. Press the activation switch on the SST  (Deployment tool) to deploy the passenger-side air bag module.
    Fig 7: Identifying Activation Switch On SST (Deployment Tool)
    G03700900Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals