LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 419 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures (Standard Deployment Control System) >> Deployment Procedure for Inside of Vehicle >> Pre-tensioner seat belt

Pre-tensioner seat belt

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the B-pillar lower trim.
  2. Remove the pre-tensioner seat belt and connect the SST  (Adapter harness) to it as shown in Fig 1.
    Fig 1: Connecting SST (Adapter Harness) To Pre-Tensioner Seat Belt
    G03700885Courtesy of MAZDA MOTORS CORP.
  3. Install the pre-tensioner seat belt.
  4. Connect the SST  (Deployment tool) to the SST  (Adapter harness).
    Fig 2: Connecting SST (Deployment Tool) To SST (Adapter Harness)
    G03700886Courtesy of MAZDA MOTORS CORP.
  5. Connect the red clip of the SST  (Deployment tool) to the positive battery terminal and the black clip to the negative battery terminal.
  6. Verify that the red light on the SST  (Deployment tool) is illuminated.
  7. Make sure all persons are standing at least 6 m {20 ft}  from the vehicle.
  8. Press the activation switch on the SST  (Deployment tool) to deploy the pre-tensioner seat belt.
    Fig 3: Identifying Activation Switch On SST (Deployment Tool)
    G03700887Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals