LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 407 (Drive Shaft) >> Drive Shaft Disassembly/Assembly >> Tripod Joint, Snap Ring Assembly Note

Tripod Joint, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the marks and install the tripod joint using a bar and a hammer.
    CAUTION:
    • Do not damage the roller.
    Fig 1: Aligning Marks And Installing Tripod Joint Using Bar And Hammer
    G03700186Courtesy of MAZDA MOTORS CORP.
  2. Install the new snap ring using a snap-ring pliers.
    CAUTION:
    • Be sure the snap ring engages correcting in the groove of the shaft.
scientia non olet · About LEMON Manuals