Circuit Open/Short Inspection: Notes
WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION .)
- Connect the SST (104 Pin Breakout Box) with the PCM disconnected.
- Tighten the connector attaching bolt.
Tightening torque
- 3.0-5.4 N.m {30-56 kgf.cm, 27-48 in.lbf}
- Inspect the following wiring harnesses for open or short circuit (continuity check).