LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 390 (Engine Mechanical (Service Information)) >> Drive Belt Replacement >> Water Pump Drive Belt

Water Pump Drive Belt

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the plug hole plate.
  2. Remove the front wheel and tire (RH).
  3. Remove the splash shield (RH).
  4. Hold down the belt while cutting as shown in Fig 1.
    CAUTION:
    • To prevent the belt from snapping back, always hold down the belt while cutting it. Also, keep your face away from the belt.
    • The belt is hot reusable.
    Fig 1: Locating Cutting Point
    G03699712Courtesy of MAZDA MOTORS CORP.
  5. Secure the water pump drive pulley and the new belt using a tie wrap.
    NOTE:
    • It is acceptable to use a tie wrap with a releasable lock.
    Fig 2: Securing Water Pump Drive Pulley And Belt Using A Tie Wrap
    G03699713Courtesy of MAZDA MOTORS CORP.
  6. Rotate the crankshaft verifying that the belt engages properly.

    Crankshaft rotating angle (reference) 

    1. Approx. 320 
  7. Verify that the belt is installed securely in the pulley groove.
    CAUTION:
    • If the belt slips while rotating the crankshaft, verify that the belt engages properly by rotating the crankshaft further.
  8. Remove the tie wrap.
    CAUTION:
    • To prevent damage to the belt, cut the tie wrap at the pulley side using the nipper or scissors when removing the tie wrap by cutting it.
    Fig 3: Locating Cutting Point
    G03699714Courtesy of MAZDA MOTORS CORP.
  9. Install the splash shield (RH)
  10. Install the front wheel and tire (RH).
  11. Install the plug hole plate.
scientia non olet · About LEMON Manuals