LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 390 (Engine Mechanical (Service Information)) >> Cylinder Head Gasket Replacement >> Cylinder Head (LH) Installation Note

Cylinder Head (LH) Installation Note

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the cylinder head bolts in the order shown using the following 6 steps.
    1. Tighten to 32-38 N.m {3.3-3.8 kgf.m, 24-28 ft.lbf}  .
    2. Tighten 85°-95°  .
    3. Loosen 360°  (one full turn) in reverse order.
    4. Tighten to 32-38 N.m {3.3-3.8 kgf.m, 24- 28 ft.lbf}  .
    5. Tighten 85°-95°  .
    6. Tighten 85°-95°  .
    Fig 1: Tightening Cylinder Head (LH) Bolts In Sequence
    G03699778Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals