LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Automatic Transmission - Diagnosis) >> Component Tests >> Solenoid Valves >> Resistance Inspection

Resistance Inspection

WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Resistance values are accurate with transaxle fluid at 68°F (20°C).

Disconnect the negative battery cable. Disconnect transaxle 12-pin connector No. 1. Measure the resistance between specified terminals. See Figure and Figure . If resistance is within specification for all solenoids, check solenoid operation. See OPERATION INSPECTION . If any resistance is not as specified, remove suspect solenoid valve from control valve body. See appropriate SERVICING article. Measure resistance at component terminals. See Figure-Figure . If resistance for any solenoid is not within specification, replace faulty solenoid. See appropriate SERVICING article.

scientia non olet · About LEMON Manuals