Rear Washer Hose Removal/Installation [5-Door, Sport Wagon]
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION [5-DOOR, SPORT WAGON] .)
- Partially peel off the right side mud guard.
- Remove rear washer hose No. 1 from the clips.
- Remove rear washer hose No. 1 and joint pipe A.
- Remove the A-pillar trim. (See A-PILLAR TRIM REMOVAL/INSTALLATION .)
- Remove rear washer hose No. 2 from clip A.
- Remove clips B from the body.
- Remove rear washer hose No. 2 and joint pipes B.
- Remove the C-pillar trim. (See C-PILLAR TRIM REMOVAL/INSTALLATION .) (5-Door)
- Remove the D-pillar trim. (Sport Wagon)
- Remove the liftgate upper trim. (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION [5-DOOR, SPORT WAGON] .)
- Remove rear washer hose No. 3 from clip C.
- Remove clips D from the body. (5-Door)
- Remove rear washer hose No. 3 and joint pipe C.
- Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION .)
- Remove the tape from rear washer hose No. 4.
- Install in the reverse order of removal.