LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Automatic Transaxle - Overhaul [FN4A-El]) >> Transaxle Reassembly >> General Precaution Notes

General Precaution Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2005 Mazda 6, 2005 Mazda 3, 2004 Mazda 6, 2004 Mazda 3, and 2003 Mazda Protege5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Select the adjustment shims. See ADJUSTMENTS .
  2. If the drive plates or 2-4 brake band are replaced with new ones, soak the new part in ATF for at least 2 hours before installation.
  3. Before assembly, apply ATF to all seal rings, rotating parts, "O" rings and sliding parts.
  4. All "O" rings, seals and gaskets must be replaced with NEW ones included in the overhaul kit.
  5. Use petroleum Jelly, not grease, when assembling.
  6. When necessary to replace a bushing, replace the subassembly that includes that bushing.
  7. Assemble the housing within 10 minutes after applying sealant, and allow it to cure for at least 30 minutes after assembly before filling the transaxle with ATF.
scientia non olet · About LEMON Manuals