LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Automatic Transaxle - Overhaul [FN4A-El]) >> Component Disassembly & Reassembly >> Forward Clutch >> Disassembly

Forward Clutch: Disassembly

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2005 Mazda 6, 2005 Mazda 3, 2004 Mazda 6, 2004 Mazda 3, and 2003 Mazda Protege5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove forward clutch hub, snap ring, retainer plate, and drive and driven plates from forward clutch drum. See Fig 1.
  2. Compress seal plate only enough to remove snap ring. Remove snap ring. Remove seal plate and spring retainer assembly. Set forward clutch drum and turbine shaft onto oil pump. Using air pressure through fluid passage, remove clutch piston from forward clutch drum. Maximum air pressure is 57 psi (4.0 kg/cm2 ). See Fig 2. Remove forward clutch drum and turbine shaft.
Fig 1: Exploded View Of Forward Clutch Assembly
G00024924Courtesy of MAZDA MOTORS CORP.
Fig 2: Removing Forward Clutch Piston & Air Checking Clutch
G00024925Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals