LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 376 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures >> Deployment Procedure for Outside of Vehicle >> Pre-tensioner seat belt

Pre-tensioner seat belt

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pre-tensioner seat belt. (See FRONT SEAT BELT REMOVAL/INSTALLATION .)
    WARNING:
    • If the pre-tensioner seat belt is not properly installed to the tire, serious injury may occur when the pre-tensioner part is deployed. When installing the pre-tensioner seat belt to the tire, make sure the pre-tensioner part is inside the tire.
  2. Connect the SST  (Adapter harness) to the pre-tensioner seat belt as shown in the figure.
    Fig 1: Connecting SST (Adapter Harness) To Pre-Tensioner Seat Belt
    G03645185Courtesy of MAZDA MOTORS CORP.
  3. With the pre-tensioner part inside the tire, tie the pre-tensioner seat belt to the tire. Wrap the wire through the tire and around the pre-tensioner seat belt at least four times  .
    Fig 2: Tying Pre-Tensioner Seat Belt To Tire
    G03645186Courtesy of MAZDA MOTORS CORP.
  4. Stack the tire with the pre-tensioner seat belt on top of two tires. Stack a tire on top of the three tires. Stack another tire that has a wheel on top of the four tires.
    Fig 3: Stacking Tires Around Pre-Tensioner Seat Belt
    G03645187Courtesy of MAZDA MOTORS CORP.
  5. Tie all tires together with wire.
    Fig 4: Tying All Tires Together With Wire
    G03645188Courtesy of MAZDA MOTORS CORP.
  6. Connect the SST  (Deployment tool) to the SST  (Adapter harness).
    Fig 5: Connecting SST (Adapter Harness) To SST (Deployment Module)
    G03645189Courtesy of MAZDA MOTORS CORP.
  7. Connect the red clip of the SST  (Deployment tool) to the positive battery terminal and the black clip to the negative battery terminal.
  8. Verify that the red light on the SST  (Deployment tool) is illuminated.
  9. Make sure all persons are standing at least 6 m {20 ft}  from the vehicle.
  10. Press the activation switch on the SST  (Deployment tool) to deploy the pre-tensioner seat belt.
    Fig 6: Locating Activation Switch On SST
    G03645190Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals