Oil Pipe, Hose Clamp, Oil Hose Installation Note

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Apply compressed air to the cooler-side opening, and blow any remaining grime and foreign material from the cooler pipes. Compressed air should be applied for no less than 1 min.

Fig 1: Applying Compressed Air To Cooler-Side Opening
Courtesy of MAZDA MOTORS CORP.
Align the marks, and slide the oil hose onto the oil pipe until it is fully seated as shown in the figure.
NOTE:
- If reusing the hose, install the new hose clamp exactly on the mark left by the previous hose camp. Then apply force to the hose clamp in the direction of the arrow in order to fit the clamp in place.
Fig 2: Aligning Marks
Courtesy of MAZDA MOTORS CORP.
Install the new hose clamp onto the hose.
Verify that the hose clamp does not interfere with any other components.