Input/Turbine Speed Sensor Removal/Installation
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until then are cool before replacing the ATF.
- Disconnect the negative battery cable.
- Remove the air cleaner component and air cleaner bracket. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
- Place the heater pipe out of the way.
- Remove the under cover.
- Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
- Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
- Disconnect the lower radiator hose and place the lower radiator hose out of the way.
- Remove the oil hose, oil pipe and O-ring. (See OIL COOLER REMOVAL/INSTALLATION .)
- Remove the front crossmember. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION .)
- Remove the control valve body. (See
ON-VEHICLE REMOVAL .)CAUTION:
- Do not damage the input/turbine speed sensor.
- Remove the input/turbine speed sensor.
- Install the input/turbine speed sensor.
Tightening torque
3.9-6.9 N.m {40-70 kgf.cm, 26-60 in.lbf}
- Install the control valve body. (See ON-VEHICLE INSTALLATION .)
- Apply ATF to a new O-ring and install it on the oil pipe.
- Install the oil pipe and oil hose. (See OIL COOLER REMOVAL/INSTALLATION .)
- Connect the lower radiator hose.
- Add the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
- Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
- Install the front crossmember. (See FRONT CROSSMEMBER REMOVAL/INSTALLATION .)
- Install the under cover.
- Install the air cleaner component and air cleaner bracket. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
- Perform the mechanical system test. (See MECHANICAL SYSTEM TEST .)