No. 1 Engine Mount and No. 4 Engine Mount Bracket Installation Note

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Verify that the engine mount rubber is installed as shown.
By aligning the holes with the stud bolts, install the No. 4 engine mount bracket to the transaxle.
By aligning the holes with the stud bolts, install the No. 1 engine mount to the transaxle.
Align the hole of the No. 4 engine mount bracket with the No. 4 engine mount rubber on vehicle, and temporarily tighten bolt D.

Fig 1: No. 4 Engine Mount Bolt Identification
Courtesy of MAZDA MOTORS CORP.
Lightly tighten nuts B, C and bolt A.
Tighten nuts B, C in order of B-->C, then bolt A.
Tighten bolt D.
Tightening torque

A, B, C: 66.6-93.1 N.m

{6.8-9.4 kgf.m, 49.2-68.6 ft.lbf}

D: 85.3-116.6 N.m

{8.7-11.8 kgf.m, 62.9-85.9 ft.lbf}
Tighten bolt E to the No. 1 engine mount.
Tightening torque

E: 85.3-116.6 N.m

{8.7-11.8 kgf.m, 62.9-85.9 ft.lbf}

Fig 2: Tightening Bolt E To No. 1 Engine Mount
Courtesy of MAZDA MOTORS CORP.
Remove the SST (49 E017 5A0).