Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NO. 26 STARTER DOES NOT WORK [AW6A-EL] DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	Perform the N position learning. (See NEUTRAL POSITION LEARNING .) Does the problem eliminate?	Yes	Troubleshooting is completed. If the other symptom occurs, go to applicable troubleshooting procedure.
1		No	Go to the next step.
2	Inspect the TR switch. (See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION .) Is the TR switch normal?	Yes	Go to engine system troubleshooting No. 3 "NO. 3 WILL NOT CRANK " troubleshooting procedure.
2		No	Replace the TR switch and perform initial learning procedure. (See INITIAL LEARNING .)
3	Verify test results. If normal, return to the diagnostic index to service any additional symptoms. If malfunction remains, inspect the related Service Bulletins and/or On-line Repair Information and perform repair or diagnosis. If the vehicle is repaired, troubleshooting completed. If the vehicle is not repaired or additional diagnostic information is not available, replace the TCM.