No. 24 Engine Stalls When Shifted To D Range, Or In R Position: Notes

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

DESCRIPTION AND POSSIBLE CAUSE

24	Engine stalls when shifted to D range, or in R position
DESCRIPTION	Engine stalls when shifting from N or P position to D range or R position at idle.
POSSIBLE CAUSE	The malfunction is on the engine control side (e.g. electronic controlled throttle system). Otherwise, the malfunction is in the input/turbine speed sensor (engine sometimes starts) or the TCC circuit (engine always stalls). NOTE: Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)

Engine stalls when shifted to D range, or in R position

DESCRIPTION

Engine stalls when shifting from N or P position to D range or R position at idle.

POSSIBLE CAUSE

The malfunction is on the engine control side (e.g. electronic controlled throttle system). Otherwise, the malfunction is in the input/turbine speed sensor (engine sometimes starts) or the TCC circuit (engine always stalls).
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See BASIC INSPECTION .)