Lateral runout inspection
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- To secure the disc plate and the hub, tighten the hub nuts upside down or insert a washer (thickness 10 mm {0.39 in}
, inner diameter more than 12 mm {0.47 in}
) between the hub bolt and the hub nut.NOTE:
- The component parts of the SST (49 B017 001 or 49 G019 003) can be used as a suitable washer.
- After tightening all the hub nuts to the same torque, put the dial gauge on the friction surface of disc plate 10 mm {0.39 in} from the disc plate edge.
- Rotate the disc plate one time and measure the runout.
Runout limit
0.02 mm {0.0008 in}