Brake Pedal Height Adjustment
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- The brake switch may not operate normally after adjusting the pedal height. Whenever adjusting the pedal height, replace the brake switch with a new one.
- Loosen locknut B and turn the bolt A until it does not contact the pedal.
- Loosen locknut D and turn rod C to adjust the height.
- Tighten the bolt with locknut B.
Tightening torque
9.8-14.7 N.m
{100-149 kgf.cm, 116-130 in.lbf}
- After adjustment, inspect the pedal play and the brake light operation.