LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (On-Board Diagnostic (Anti-Lock Brakes)) >> DTC C1414 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC C1414 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 INSPECT ABS/TCS HU/CM FOR MISMATCHED INSTALLATION 
  • Verify ABS/TCS HU/CM part number
  • Has a ABS/TCS HU/CM with the correct part number been installed?
 Yes Go to next step.
No Replace with correct ABS/TCS HU/CM part number, then go to Step 7.
2 INSPECT RELATED WIRING HARNESS FOR MISMATCHED INSTALLATION 
  • Verify wiring harness part number
  • Has a wiring harness with the correct part number been installed?
 Yes Go to next step.
No Replace with correct ABS/TCS HU/CM part number, then go to next Step.
3 Configure ABS/TCS HU/CM 
  • Can ABS/TCS HU/CM configure properly?
 Yes Go to next step.
No Replace ABS/TCS HU/CM
4 VERIFY TROUBLESHOOTING COMPLETED 
  • Make sure to reconnected all disconnect connectors.
  • Clear DTC from memory.

    (See CLEARING DTCS PROCEDURES  )

  • Is same DTC present?
 Yes Replace ABS/TCS HU/CM, then go to next step.
No Go to next step.
5 VERIFY AFTER REPAIR PROCEDURE 
  • Is there any other DTC present?
 Yes Go to applicable DTC inspection.
No Troubleshooting completed.
scientia non olet · About LEMON Manuals