LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (On-Board Diagnostic (Anti-Lock Brakes)) >> DTC C1119 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC C1119 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 CHECK FOR PCM FOR DTCs 
  • Turn the ignition switch off.
  • Connect WDS or equivalent to DLC-2
  • Turn ignition key to ON (engine off).
  • Is DTC for engine control system obtained?
 Yes Follow inspection procedures for engine control system.
No Go to the next step.
2 VERIFY TROUBLESHOOTING COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear the DTC from the memory.

    (See CLEARING DTCS PROCEDURE  )

  • Start engine.)
  • Is same DTC present?
 Yes Replace ABS/TCS HU/CM, then go to the next step.
No Go to the next step.
3 VERIFY AFTER REPAIR PROCEDURE 
  • Is there any other DTC present?
 Yes Go to the applicable DTC inspection.
No Troubleshooting completed.
scientia non olet · About LEMON Manuals