LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 357 (On-Board Diagnostic (Anti-Lock Brakes)) >> DTC B1342 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DTC B1342 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY CURRENT STATUS OF MALFUNCTION 
  • Clear the DTC from the memory.

    (See CLEARING DTCS PROCEDURES  )

  • Start engine and drive vehicle at 10 km/h {6.2 mph}  or above.
  • Is same DTC present?
 Yes Replace ABS/TCS HU/CM, then go to the next step.
No Inspect intermittent concern using the same procedure as engine control system.
2 VERIFY AFTER REPAIR PROCEDURE 
  • Is there any other DTC present?
 Yes Go to the applicable DTC inspection.
No Troubleshooting completed.
scientia non olet · About LEMON Manuals