Clip Installation Note
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new clip onto the drive shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on installation.
- After installation, measure the outer diameter. If it exceeds the specification, repeat steps 1-2 using a new clip.
Outer diameter specification
MTX: 32.1-33.2 mm {1.27-1.30 in}
ATX: 33.1-34.0 mm {1.31-1.33 in}