LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Drive Shaft) >> Drive Shaft Disassembly/Assembly [MTX] >> Cage, Inner Ring, Balls, Snap Ring Assembly Note

Cage, Inner Ring, Balls, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the marks and install the balls and cage to the inner ring in the direction shown in the figure.
    CAUTION:
    • Install the cage with the offset facing the snap ring groove. If incorrectly installed, the drive shaft may become disengaged.
  2. Install a new snap ring.
    Fig 1: Installing Balls And Cage To Inner Ring In Direction Shown
    G03644434Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals