LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Drive Shaft) >> Drive Shaft Disassembly/Assembly [MTX] >> Balls, Inner Ring, Cage Disassembly Note

Balls, Inner Ring, Cage Disassembly Note

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Mark the inner ring and cage.
    CAUTION:
    • Mark with paint; do not use a punch.
  2. Remove the snap ring using snap-ring pliers.
  3. Turn the cage approximately 22.5 degree  and pull the cage and balls away from the inner ring.
    Fig 1: Turning Cage 22.5 Degree And Pulling Cage And Balls Away From Inner Ring
    G03644432Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals