LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Manual A/C-Heater Systems - HVAC) >> Blower Motor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH A-pillar lower trim.
    Fig 1: Removing/Installing Blower Motor
    G01162292Courtesy of MAZDA MOTORS CORP.
  2. Remove the blower motor.
    1. Disconnect the electrical connector.
    2. Remove the washer screws.
    3. Remove the blower motor and cover, lower the assembly from the housing.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals