Air Conditioning (A/C) Compressor Shaft Seal: Installation

WARNING: This page is about a different car, the 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

To prevent refrigerant system contamination, do not allow dirt or other foreign materials to enter the A/C compressor.

Clean the A/C compressor nose area.

Fig 1: Placing Shaft Seal On The Special Tool
Courtesy of MAZDA MOTORS CORP.
Lubricate the shaft seal and special tool with PAG Compressor Oil. Place the shaft seal on the special tool.

Fig 2: Positioning The Special Tool
Courtesy of MAZDA MOTORS CORP.
Position the special tool, with the shaft seal, over the A/C compressor shaft.

Fig 3: Pushing Shaft Seal Onto The A/C Compressor Shaft
Courtesy of MAZDA MOTORS CORP.
Using the special tool, push the shaft seal onto the A/C compressor shaft until seated.

Fig 4: Installing Shaft Seal Snap Ring.
Courtesy of MAZDA MOTORS CORP.
Using the special tool, install the shaft seal snap ring.
Carry out the A/C compressor external leak test. For additional information, refer to A/C COMPRESSOR EXTERNAL LEAK TEST .

Fig 5: Installing Shaft Seal Felt
Courtesy of MAZDA MOTORS CORP.
Using the special tool, install the shaft seal felt.
Install the disk and hub assembly. For additional information, refer to CLUTCH AND CLUTCH FIELD COIL .