Airflow Inspection

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Perform the following test only when directed.

Disconnect the negative battery cable.
Remove the purge solenoid valve. (See PURGE SOLENOID VALVE INSTALLATION NOTE .)
Inspect airflow between the ports under the following conditions.
- If not as specified, replace the purge solenoid valve.
- If as specified, carry out the "Circuit Open/Short Inspection".
  
  Fig 1: Purge Solenoid Valve Continuity Table
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Inspecting Purge Solenoid Valve
  Courtesy of MAZDA MOTORS CORP.