Resistance Inspection: Notes
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Perform the following procedure only when directed.
- Disconnect the negative battery cable.
- Inspect resistance of the EVAP system leak detection pump.
- If not as specified, replace the EVAP system leak detection pump.
- If as specified, carry out the "Circuit Open/Short Inspection".
TERMINALS RESISTANCE SPECIFICATIONTerminals Resistance (ohm) A-B 20-50 A-C 26.6-32.4 A-D MAX. 118