LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 336 (Engine Mechanical (Service Information AJ)) >> Oil Control Valve (OCV) Inspection >> Spool Valve Operation Inspection

Spool Valve Operation Inspection

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the oil control valve (OCV).
  3. Verify that the spool valve in the oil control valve (OCV) is in the maximum valve timing retard position as indicated in the figure.
    • If not as specified, replace the oil control valve (OCV).
  4. Verify that the battery is fully charged.
    • If not as specified, recharge the battery.
      Fig 1: Identifying Spool Valve In Maximum Valve Timing Retard Position
      G03643791Courtesy of MAZDA MOTORS CORP.
  5. Apply battery positive voltage between the oil control valve (OCV) terminals and verify that the spool valve operates and moves to the maximum valve timing advance position.
    Fig 2: Identifying Oil Control Valve Connector Terminals
    G03643792Courtesy of MAZDA MOTORS CORP.
    • If not as specified, replace the oil control valve (OCV).
    NOTE:
    • When applying battery positive voltage between the oil control valve (OCV) terminals, the connection can be either of the following:
      • Positive battery cable to terminal A, negative battery cable to terminal B
      • Positive battery cable to terminal B, negative battery cable to terminal A
  6. Stop applying battery positive voltage and verify that the spool valve returns to the maximum valve timing retard position.
    • If not as specified, replace the oil control valve (OCV).
      Fig 3: Identifying Spool Valve At Maximum Valve Timing Advance Position
      G03643793Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals