Vacuum Reservoir Tank And Bracket Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The vacuum reservoir tank and bracket is located either on or beneath the RH front fender splash shield.

Remove the engine Air Cleaner (ACL).
Remove the RH front fender splash shield. See FRONT SPLASH SHIELD REMOVAL/INSTALLATION .
Remove the nuts and remove the A/C vacuum reservoir tank and bracket.

Fig 1: Removing A/C Vacuum Reservoir Tank & Bracket
Courtesy of MAZDA MOTORS CORP.
Disconnect the vacuum supply and outlet hoses.

Fig 2: Disconnecting Vacuum Supply & Outlet Hoses
Courtesy of MAZDA MOTORS CORP.
To install, reverse the removal procedure.
Tightening Torque

7-9 N.m {71-92 kgf.Cm, 62-79 in.lbf}.