Heater Outlet Floor Duct Removal/Installation

WARNING: This page is about a different car, the 2002 Mazda B4000, 2002 Mazda B3000, and 2002 Mazda B2300. However, it is still accessible from the selected car via links, so may be relevant.

Remove the plenum chamber; see PLENUM CHAMBER REMOVAL/INSTALLATION .
Remove the screws and remove the heater outlet floor duct.
Install in reverse order of removal.

Tightening Torque

2-3 N.m {20-30 kgf.Cm, 18-26 in.lbf}.

Fig 1: Removing Heater Outlet Floor Duct

Courtesy of MAZDA MOTORS CORP.