Exhaust Manifold - LH: Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Manifold Tightening Sequence

Courtesy of MAZDA MOTORS CORP.

Position a new gasket and tighten the exhaust manifold in the sequence shown.

Fig 2: Installing A/C Compressor Bolts
Courtesy of MAZDA MOTORS CORP.
Position the A/C compressor and install the bolts.
Install the accessory drive belt. Refer to ACCESSORY DRIVE BELT - 3.0L DURATEC (4V) .

Fig 3: Installing Exhaust Crossover
Courtesy of MAZDA MOTORS CORP.
Install the exhaust crossover.

Fig 4: Installing Splash Shield
Courtesy of MAZDA MOTORS CORP.
Install the splash shield.
Install the LH HO2S. Refer to HEATED OXYGEN SENSOR .