Malfunction Indicator Lamp (MIL)

The malfunction indicator lamp (MIL) alerts the driver that the PCM has detected an OBD II emission-related component or system fault. When this occurs, a DTC will be set.

• The MIL is located on the instrument cluster and is labeled CHECK ENGINE.
• Power is supplied to the MIL whenever the ignition switch is in the ON or START position.
• The MIL will remain on in the ON / START mode as a bulb check during the instrument cluster prove out for approximately 4 seconds.
• If the MIL remains on after the bulb check:
  • The PCM illuminates the MIL for an emission-related concern and a DTC will be present.
  • The instrument cluster will illuminate the MIL if the PCM does not send a control message to the instrument cluster.
  • The PCM is operating in the Hardware Limited Operation Strategy (HLOS).
  • The MIL circuit is shorted to ground.
• If the MIL remains off (during the bulb check):
  • Bulb is damaged.
  • MIL circuit is open.
• To turn off the MIL after a repair, a reset command from the WDS or equivalent must be sent, or three consecutive drive cycles must be completed without a fault.
• If the MIL blinks at a steady rate, a severe misfire condition could possibly exist.
• If the MIL blinks erratically, an intermittent open B+ to the bulb or an intermittent short to ground in the MIL circuit exist. Also, the PCM can reset while cranking if battery voltage is low.