Removal and Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Remove the tire and wheel. Refer to WHEELS AND TIRES .

Fig 1: Positioning Inner Fender Well Aside
Courtesy of MAZDA MOTORS CORP.
Position the inner fender well aside.
1. Remove the bolts.
2. Remove the pin-type retainers.
3. Remove the screw.
4. Position the inner fender well aside.
  
  Fig 2: Disconnecting Electrical Bulb Assembly And Position Aside
  Courtesy of MAZDA MOTORS CORP.
Disconnect the electrical bulb assembly and position aside.

Fig 3: Removing Fog Lamp Assembly
Courtesy of MAZDA MOTORS CORP.
Remove the fog lamp assembly.
1. Remove the bolts.
2. Remove the fog lamp assembly.
  
  Fig 4: Removing Fog Lamp From Fog Lamp Bracket
  Courtesy of MAZDA MOTORS CORP.
NOTE:
- This step may not be necessary if the fog lamp comes with bracket.
Remove the fog lamp from the fog lamp bracket.
1. Remove the adjusting screw and spring.
2. Squeeze the top and bottom of the fog lamp bracket.
3. Remove the fog lamp from the fog lamp bracket.
To install, reverse the removal procedure.