Removal and Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Pin-Type Retainers (Three Each Side)

Courtesy of MAZDA MOTORS CORP.

Remove the six pin-type retainers (three each side).

Fig 2: Removing Front Bumper Cover Bolts (Two Each Side)
Courtesy of MAZDA MOTORS CORP.
Remove the four front bumper cover bolts (two each side).

Fig 3: Removing Front Bumper Cover To Front Fender Pin-Type Retainers (One Each Side)
Courtesy of MAZDA MOTORS CORP.
Remove the two front bumper cover to front fender pin-type retainers (one each side).
If equipped, disconnect the fog lamp electrical connectors.

Fig 4: Removing Lower Front Bumper Cover Bolts
Courtesy of MAZDA MOTORS CORP.
Remove the lower front bumper cover bolts.

Fig 5: Removing Pin-Type Retainers
Courtesy of MAZDA MOTORS CORP.
Remove the pin-type retainers.

Fig 6: Removing Upper Bolts (One Each Side) And Front Bumper Cover
Courtesy of MAZDA MOTORS CORP.
Remove the two upper bolts (one each side) and the front bumper cover.
To install, reverse the removal procedure.
1. When installing, be sure to position the front bumper cover into the bumper slides.
2. Transfer components as necessary.