LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Controls - Removal, Overhaul & Installation) >> Cooling System >> Cooling System Bleeding >> MPV

Cooling System Bleeding: MPV

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Cooling system is filled through coolant reservoir.
  1. Add correct coolant mixture to "FULL" mark on coolant reservoir.
  2. Tighten cooling system cap on reservoir.
  3. Start engine and allow to idle until cooling fan operates.
  4. After engine warms up, perform following steps.
    1. Run engine at 4000 RPM for one minute.
    2. Run engine at idle for one minute.
    3. Repeat steps (a) and (b) several times.
    4. Turn on main and rear heaters (if equipped) and verify heat from heater vents.
  5. Stop engine and wait until it is cool.
  6. Inspect coolant level. If coolant level is low, repeat Steps  1- 5 .
  7. Verify there is no coolant leakage.
scientia non olet · About LEMON Manuals