LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Controls - Removal, Overhaul & Installation) >> Cooling System >> Cooling System Bleeding >> 626

Cooling System Bleeding: 626

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slowly pour coolant into radiator up to coolant filler port (2.0L) or into engine up to coolant filler port (2.5L).
  2. Add correct engine coolant mixture to reservoir until coolant level is at "F" mark. Install coolant reservoir cap.
  3. Fully install radiator cap (2.0L) or engine filler cap (2.5L) and coolant reservoir cap. See Figure.
  4. Start engine and idle for about 10 minutes.
    NOTE: If coolant temperature becomes too high, stop engine to prevent it from overheating. Repeat steps  1- 3 .
  5. After engine warms up, run it at about 2500 RPM for 5 minutes.
  6. Increase engine speed to about 3000 RPM for 5 minutes, then return to idle. Repeat several times.
  7. Stop engine and wait until it is cool.
  8. Inspect coolant level.
  9. Inspect for coolant leakage.
scientia non olet · About LEMON Manuals