LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Camshaft Synchronizer - 3.0L >> Installation

Camshaft Synchronizer - 3.0L: Installation

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Mazda Tribute, 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, and 2001 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install Synchro Positioner (303-589) on synchronizer housing. See Fig 1. Rotate synchronizer shaft until vane on shaft aligns with slot on synchro positioner. Rotate synchro positioner until engaged into notch in housing. Dip drive gear in engine oil.
    2. NOTE: During installation, the arrow on the sychro positioning tool will rotate clockwise until oil pump intermediate shaft and camshaft gear engages.
  2. Install camshaft synchronizer housing assembly. the arrow on the synchro positioning tool should be 38 degrees from centerline of engine. See Fig 3.
  3. Install hold-down clamp and tighten bolt to specification. See TORQUE SPECIFICATIONS . Install CMP sensor to synchronizer and tighten to specification. Reconnect wiring to CMP sensor. Connect negative battery cable.
Fig 1: Installing Synchro Positioner On Synchronizer Assembly (Typical)
G95I35855Courtesy of FORD MOTOR CO.
Fig 2: Exploded View Of CMP Synchronizer Assembly
G95H35854Courtesy of FORD MOTOR CO.
Fig 3: Installing Camshaft Synchronizer
G00205855Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals