Halfshaft Handling
WARNING: This page is about a different car, the 2004 Mazda Tribute and 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Never pick up or hold the halfshaft only by the inboard or outboard CV joint.
CAUTION:
- Do not over-angle the CV joints.
CAUTION:
- Damage will occur to an assembled inboard CV joint if it is over-plunged outward from the joint housing.
CAUTION:
- Never use a hammer to remove or install the halfshafts.
CAUTION:
- Never use the halfshaft assembly as a lever to position other components. Always support the free end of the halfshaft.
CAUTION:
- Do not allow the boots to contact sharp edges or hot exhaust components.
CAUTION:
- Handle the halfshaft only by the inter-connecting shaft to avoid pull-apart and potential damage to the CV joints.
CAUTION:
- Do not drop assembled halfshafts. The impact will cut the boots from the inside without evidence of external damage.
Handle all halfshaft components carefully during removal and installation procedures.