Starter Motor - 3.0L DURATEC (4V): Removal

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

When repairing the starter motor or working underhood in the vicinity of the starter motor, note the heavy gauge input lead connected to the starter solenoid is hot at all times. Make sure the protective cap is installed over the terminal and is reinstalled after repairing. Failure to follow these instructions may result in personal injury.

Disconnect the battery ground cable. .
Remove the air cleaner outlet tube and the air cleaner assembly. .
Drain the engine cooling system. Refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .

Fig 1: Disconnecting Three Hoses And Positioning Thermostat Aside
Courtesy of MAZDA MOTORS CORP.
Disconnect the three hoses and position the thermostat aside.

Fig 2: Removing Nuts And Positioning Starter Solenoid Cables Aside
Courtesy of MAZDA MOTORS CORP.
Remove the nuts and position the starter solenoid cables aside.

Fig 3: Removing Two Bolts And Starter Motor
Courtesy of MAZDA MOTORS CORP.
Remove the two bolts and the starter motor.
To install, reverse the removal procedure.