Removal and Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

When repairing the starter motor or working underhood in the vicinity of the starter motor, note the heavy gauge input lead connected to the starter solenoid is hot at all times. Make sure the protective cap is installed over the terminal and is reinstalled after repairing. Failure to follow these instructions may result in personal injury.

Disconnect the battery ground cable. .

Fig 1: Removing Starter Bolts
Courtesy of MAZDA MOTORS CORP.
Remove the starter bolts.
Raise and support the vehicle. .

Fig 2: Removing Halfshaft Support Bracket Bolts And Nuts
Courtesy of MAZDA MOTORS CORP.
Remove the halfshaft support bracket bolts and nuts.

Fig 3: Removing Battery Cable And Starter Control Electrical Connector Nuts
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Generator removed from illustration for clarity.
Remove the battery cable and starter control electrical connector nuts.
Remove the starter.
To install, reverse the removal procedure.