Cooling Fan Motor Inspection: AJ
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Verify that the battery is fully charged.
- Disconnect the fan control module connector (3 terminals).
- Connect the positive battery voltage and an ammeter to the fan control module connector on fan motor side. (2 terminals)
- Verify that the fan motor operates smoothly at the standard current draw.
- If not as specified, replace the fan motor.
- Perform the same procedure as Step 2 for the cooling fan motor No.2.
- Standard current [12 V] 11.8-14.8 (A)