LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 258 (Engine Mechanical - Overhaul) >> Engine Disassembly/Assembly >> Cylinder Head Disassembly/Assembly (I) >> Camshaft Cap Assembly Note

Camshaft Cap Assembly Note

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata, 2004 Mazda MX-5 Miata, and 2003 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply silicone sealant to the shaded areas shown in the figure.
    Fig 1: Applying Silicone Sealant
    G02831710Courtesy of MAZDA MOTORS CORP.
  2. Install the camshaft caps to the positions from which they were removed.
  3. Tighten the camshaft cap bolts in two or three steps in the order shown.
    Fig 2: Camshaft Cap Bolt Tightening Sequence
    G02831711Courtesy of MAZDA MOTORS CORP.
  4. Apply clean engine oil to the lip of the new camshaft oil seal.
  5. Push the oil seal slightly in by hand.
  6. Press the oil seal in evenly by using the SST  .
    Fig 3: Installing Oil Seal
    G02831712Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals