Cut-Off Seal Inspection
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 Mazda RX-8, 2010 Mazda RX-8, 2009 Mazda RX-8, 2008 Mazda RX-8, and 2007 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Measure the cut-off seal height using a vernier caliper.
- If it is less than the minimum specification, replace the cut-off seal.
CAUTION:- Measure the cut-off seal height around the complete perimeter.
Standard Height
- 3.95 mm {0.1555 in}
Minimum Height
- 3.8 mm {0.15 in}