Resistance Inspection

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Perform the following procedure only when directed.

Disconnect the negative battery cable.
Inspect resistance of the EVAP system leak detection pump.
- If not as specified, replace the EVAP system leak detection pump.
- If as specified, carry out the "Circuit Open/Short Inspection".
Fig 1: EVAP System Leak Detection Pump Resistance Specifications
Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying EVAP System Leak Detection Pump Terminals Connection
Courtesy of MAZDA MOTORS CORP.

Fig 3: Identifying EVAP System Leak Detection Pump Connector Terminals
Courtesy of MAZDA MOTORS CORP.