Ignition Timing Inspection
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- The ignition timing cannot be adjusted.
- The WDS or equivalent is required to verify the ignition timing.
- Complete the engine tune-up preparation. (See ENGINE TUNE-UP PREPARATION .)
- Connect the timing light to the front rotor housing on the leading side.
- Turn the test mode on using the test simulation function.
- Verify that the eccentric shaft position plate alignment mark (white) and the front cover mark (white) is aligned.NOTE:
- When using the WDS or equivalent, verify that the ignition (WDS: SPARK-L) is -5°.
- If there is a malfunction, refer to SYMPTOM TROUBLESHOOTING [ENGINE CONTROL SYSTEM .)
- Turn the test mode off using the test simulation function.