LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Controls - Basic Diagnostic Procedures) >> Ignition Checks >> Except B2300, B3000, B4000 & Tribute >> Crankshaft Position Sensor Air Gap (Except MPV)

Crankshaft Position Sensor Air Gap (Except MPV)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: MPV air gap inspection and specification not available from manufacturer.

Using a feeler gauge, measure air gap between crankshaft pulley and Crankshaft Position (CKP) sensor. See Fig 1 -Fig 5 . If air gap is not .020-.060" (.5-1.5 mm), replace crankshaft pulley or CKP sensor. On Miata, CKP sensor is adjustable. If sensor will not adjust, replace CKP sensor or plate behind crankshaft pulley.

Fig 1: Checking CKP Sensor Air Gap (Miata)
G00110120Courtesy of MAZDA MOTORS CORP.
Fig 2: Checking CKP Sensor Air Gap (Millenia 2.3L)
G00110121Courtesy of MAZDA MOTORS CORP.
Fig 3: Check CKP Sensor Air Gap (Millenia & 626 2.5L)
G00110122Courtesy of MAZDA MOTORS CORP.
Fig 4: Checking CKP Sensor Air Gap (Protege & Protege5)
G00110123Courtesy of MAZDA MOTORS CORP.
Fig 5: Checking CKP Sensor Air Gap (626 2.0L)
G00110124Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals