LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 5 Grand Touring >> Repair and Diagnosis >> External Pages >> Different car >> Section 228 (Body Panels) >> Front Bumper Reinforcement Removal/Installation

Front Bumper Reinforcement Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the front side marker lights. (See FRONT SIDE MARKER LIGHT REMOVAL/INSTALLATION .)
  3. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION  .)
  4. Remove fasteners A, then remove the energy-absorbing foam.
    Fig 1: Removing/Installing Front Bumper Reinforcement
    G01344266Courtesy of MAZDA MOTORS CORP.
  5. Remove fasteners B, then remove front bumper retainer No.2.
  6. Remove the bolts, then remove the front bumper reinforcement.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals